By Scott
I've not been a big advocate of bells until recently. Most of my riding for years was on roads - ideally small lane ways or back roads where traffic of any kind - vehicular or pedestrian - was light to non existent. Didn't feel the need for a bell if I was rolling along those sort of places, but lately I've been on more bike paths and such, where interactions with pedestrians is more common and I find myself using a bell more often. The rise of folks wearing ear buds while out walking means that the old trick of back pedaling and clicking the brake levers doesn't seem to work when folks are walking along a path listening to the latest Taylor Swift album. My experience so far as been that our bells seem to have a tone that people respond to well. It's not harsh like a horn, but more of a gentle reminder to folks that others are out there and would like to pass alongside them.
So I hear you saying, "Gee Scott, that sounds a lot like how my riding has been going. How do I get a bell mounted to my bike?" Well, glad you asked, 'cause we've got a blog post to help you figure out what will work for you.
Now all these options are based on using our
Temple bell, brass or silver - you choose to match or contrast the build you have on your bike. The
brass striker bell will work with option #1 and 2 only.
Set up #1 - Handlebars - If you have standard road bars or flat bars, you can clamp the bar right to the handlebars. Use a flat head or Philips screwdriver to loosen the clamp from the packaging, put it on the left or right side of the bar (I'd go with the dominant hand side) and then tighten it up. Done.
(Silver bell mounted on VO quill stem)
Set up #2 - Quill stem - A 1" quill stem is the right diameter to attach a bell to. So if you have no room on the bars, you can clamp the bell around the quill portion of the stem. Same rule as #1 - set up bell on dominant hand side. Done.
(Silver bell mounted to retro spacer)
Set up #3 - Spacer replacement - We have a couple options for this. You can replace one of the spacers in your headset (1 inch or 1 1/8") with our
bell spacer mount. Or you can use the
retro spacer if you have a 1 inch headset without a lot of extra room.
Set up #4 - GC stem - On our top of the line
Grand Cru quill stem, we have a threaded attachment point about an inch below the top of the quill portion. You can screw the temple bell right into this, in the same way that the constructeur builders of the 50's and 60's did it. Igor did a nice write up
here with some great photos.
(Brass bell mounted to shifter boss)
Set up #5 - Shifter boss attachment - All our frames have braze on's on the down tube for running down tube shifters or cool cable stops. But let's say you are running a 1 X set up and the left shifter boss is not being used. Well, here's a great opportunity to put a bell there. Fasten a
down tube cover to keep it looking clean. Install a set screw and nut into the bell and screw the bell straight into the boss and voila, you're ready to rock.
Anyone have another place that they've put one of our bells?